C2002 Speed Controller Product Description:
Single closed-loop control circuit design;
Excellent steady-state control performance,;
Start-up fuel volume adjustable, ramp adjustable acceleration function;
Steady-state adjustment rate: 1~5% adjustable;
Speed fluctuation rate:≤±0.25%.
Wiring instructions of C2002 speed controller:
1. One and two feet are connected to the electromagnetic actuator cable.
2. The third and fourth pins are connected to the speed sensor cable.
3. The fifth and sixth pins are connected to the battery power supply, 5 is the - pole, 6 is the + pole
4. Pins 7 and 9 are connected to the speed trimmer potentiometer
5. Pins 7 and 12 are connected to the high and low speed switch
6. When the 10th and 11th pins are short-circuited, it is effective to adjust the steady-state rate adjustment (applicable when the unit is connected to the grid)
7. The 13th pin is the input voltage interface (suitable for self-load distribution when connected to the grid)
8. The 14th pin is the interface for the output voltage of 10V